Mounting

The Protege DIN Rail range is supplied as DIN Rail mount modules and are designed to mount on standard DIN Rail either in dedicated DIN cabinets, Protege Jumbo Cabinet Enclosure with DIN Rail Gear Plates, or generic DIN Rail mounting strip. A section of this DIN Rail strip is provided as a mounting option.

When installing the DIN Rail module ensure that there is adequate clearance around all sides of the enclosure and air flow to the vents of the unit is not restricted. It is recommended to install the unit in a location that will facilitate easy access for wiring. It is also recommended that the unit is installed in electrical rooms, communication equipment rooms, closets or in an accessible area of the ceiling.

1. Hook the lower tabs under the bottom edge of the DIN Rail.
2. Push the unit against the DIN Rail mount and press firmly on the top center of the Controller until the upper tab clips over the upper rail.

To reduce the risk of damage caused by debris during the installation, install the cabinet enclosure when the unit is not installed on the rails.